D-Link DES-1210-52/ME - Config Traffic Trap

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
177
Command: show traffic control 1-3
Traffic Storm Control Trap : [None]
Port Thres Broadcast Multicast Unicast Action Count Time
hold Storm Storm Storm down Interval
---- ------- ------------- ------------ --------- ----------- --------- -----------
1 64 Enabled Enabled Disabled Drop 0 0
2 64 Enabled Enabled Disabled Drop 0 0
3 64 Enabled Enabled Disabled Drop 0 0
Total Entries : 3
DES-1210-52/ME:5#
config traffic trap
Purpose
To configure the traffic control trap on the Switch.
Syntax
config traffic trap [storm_cleared | storm_occured | both | none]
Description
The config traffic trap command configures the current storm traffic
trap configuration on the Switch.
Parameters
storm_cleared – A notification will be generated when a storm event
is cleared.
storm_occured – A notification will be generated when a storm event
is detected.
both – A notification will be generated both when a storm event is
detected and cleared.
none – No notification will be generated when storm event is
detected or cleared.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To configure traffic trap setting:
DES-1210-52/ME:5# config traffic trap both
Command: config traffic trap both
Success.
DES-1210-52/ME:5#