D-Link DES-1210-52/ME - Time and Sntp Commands; Config Sntp

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
319
42
TIME AND SNTP COMMANDS
The Time and SNTP commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
config sntp
{primary [<ipaddr> | <ipv6addr>] | secondary [<ipaddr> | <ipv6addr>] | poll-
interval <sec 30-99999>}
show sntp
enable sntp
disable sntp
config time
<date> <systime>
config time_zone
operator
[+ hour <gmt_hour 0-13> minute <minute 0-59> | - hour <gmt_hour 0-12> minute
<minute 0-59>]
config dst
[disable | [annual s_date <start_date 1-31> s_mth <start_mth 1-12> s_time
<start_time> end_date <int 1-31> e_mth <end_mth 1-12> e_time <end_time> |
offset [30 | 60 | 90 | 120]]]
show time
Each command is listed in detail, as follows:
config sntp
Purpose
To setup SNTP service.
Syntax
config sntp {primary [<ipaddr> | <ipv6addr>] | secondary
[<ipaddr> | <ipv6addr>] | poll-interval <sec 30-99999>}
Description
The config sntp command configures SNTP service from an SNTP
server. SNTP must be enabled for this command to function (See
enable sntp).
Parameters
primary [<ipaddr>| <ipv6addr>] – Specifies the IPv4 or IPv6 address
of the primary SNTP server.
secondary [<ipaddr>| <ipv6addr>] – Specifies the IPv4 or IPv6
address of the secondary SNTP server.
poll-interval <sec 30-99999> – The interval between requests for
updated SNTP information. The polling interval ranges from 60
seconds (1 minute) to 86,400 seconds (1 day).
Restrictions
Only administrator or operate-level users can issue this command.
SNTP service must be enabled for this command to function (enable
sntp).
Example usage:
To configure SNTP settings: