DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
162
instance_id.
remove_vlan − Along with the vid_range <vidlist> parameter, this
command will remove VIDs to the previously configured STP
instance_id.
<vidlist> − Specify the VID range from configured VLANs set on the
Switch. Supported VIDs on the Switch range from ID number 1 to
4094.
Only administrator-level users can issue this command.
Example usage:
To configure instance ID 1 to add VID 10:
DES-1210-52/ME:5# config stp instance_id 1 add_vlan 10
Command: config stp instance_id 1 add_vlan 10
Success.
DES-1210-52/ME:5#
To update the MSTP configuration identification.
config stp mst_config_id [revision_level <int 0-65535> | name
<string 32>]
The config stp mst_config_id command uniquely identifies the
MSTP configuration currently configured on the Switch. Information
entered here is attached to BDPU packets as an identifier for the
MSTP region to which it belongs. Switches having the same
revision_level, name and identical vlans mapped for STP
instance_ids are considered to be part of the same MSTP region.
revision_level <int 0-65535>– The MSTP configuration revision
number. The value may be between 0 and 65535. This value, along
with the name and identical vlans mapped for STP instance_ids
identifies the MSTP region configured on the Switch. The default
setting is 0.
name <string 32> - A string of up to 32 alphanumeric characters to
uniquely identify the MSTP region on the Switch. This name, along
with the revision_level value and identical vlans mapped for STP
instance_ids identifies the MSTP region configured on the Switch. If
no name is entered, the default name is the MAC address of the
device.
Only administrator-level users can issue this command.
Example usage:
To configure the MSTP region of the Switch with revision_level 10:
DES-1210-52/ME:5# config stp mst_config_id revision_level 10
Command: config stp mst_config_id revision_level 10
Success.
DES-1210-52/ME:5#
To Next Page
Loading...
