D-Link DES-1210-52/ME - Show 802.1 X; Show 802.1 X Auth_State

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
302
Success.
DES-1210-52/ME:5#
show 802.1x
Purpose
To display the 802.1x server information on the Switch.
Syntax
show 802.1x
Description
The show 802.1x command displays the 802.1x Port-based
Network Access control server application on the Switch.
Parameters
None.
Restrictions
None.
Example usage:
To display 802.1x on the Switch:
DES-1210-52/ME:5# show 802.1x
Command: show 802.1x
802.1X : Enable
Authentication Mode : Port_base
Authentication Method : Local
Success.
DES-1210-52/ME:5#
show 802.1x auth_state
Purpose
To display the current authentication state of the 802.1x server on the
Switch.
Syntax
show 802.1x auth_state {ports <portlist>}
Description
The show 802.1x auth_state command displays the current 802.1x
authentication state of the specified ports of the Port-based Network
Access Control server application on the Switch.
The following details are displayed:
Port number − Shows the physical port number on the Switch.
Auth PAE State: Initialize / Disconnected / Connecting / Authenticating
/ Authenticated / Held / ForceAuth / ForceUnauth − Shows the current
state of the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initialize / Success. /
Timeout − Shows the current state of the Backend Authenticator.
Port Status: Authorized / Unauthorized − Shows the result of the
authentication process. Authorized means that the user was
authenticated, and can access the network. Unauthorized means that
the user was not authenticated, and cannot access the network.
Parameters
ports <portlist> − A port or range of ports whose settings are to be
displayed.
Restrictions
None.
Example usage:
To display the 802.1x authentication states for port 1~5 (stacking disabled) for Port-based 802.1x: