D-Link DES-1210-52/ME - Enable Jumbo_Frame; Disable Jumbo_Frame

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
14
IP Address : 10.90.90.90 (Manual)
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
System Boot Version : 1.00.010
System Firmware Version : 20.01.B082
System Hardware Version : C1
System Serial Number : QBDES12105200
System Name :
System Location :
System up time : 1 days, 23 hrs, 50 min, 34 secs
System Contact :
System Time : 02/01/2014 23:50:22
STP : Disabled
GVRP : Disabled
IGMP Snooping : Disabled
VLAN Trunk : Disabled
802.1X Status : Disabled
Telnet : Enabled (TCP 23)
Web : Enabled (TCP 80)
DES-1210-52/ME:5#
enable jumbo_frame
Purpose
To enable jumbo frames on the device.
Syntax
enable jumbo_frame
Description
The enable jumbo_frame command enables jumbo frames on the
device.
Parameters
None.
Restrictions
Only Administrator or operate-level users can issue this command.
Jumbo frames will be enabled after save and restart.
Example usage:
To enable jumbo frames:
DES-1210-52/ME:5# enable jumbo_frame
Command: enable jumbo_frame.
Success.
DES-1210-52/ME:5#
disable jumbo_frame
Purpose
To disable jumbo frames on the device.
Syntax
disable jumbo_frame
Description
The disable jumbo_frame command disables jumbo frames on the
device.
Parameters
None.