D-Link DES-1210-52/ME - Ssh Commands; Enable Ssh

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
350
50
SSH COMMANDS
The SSH commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable ssh
disable ssh
config ssh algorithm
[3DES | MD5 | RSA | SHA1] [disable | enable]
config ssh authmode
[publickey | hostbased | password] [enable | disable]
show ssh authmode
config ssh server
[authfail <int 2-20> | contimeout <sec 120-600> | maxsession <int 1-4> | rekey
[10min | 30min | 60min | never]]
show ssh server
show ssh algorithm
config ssh user
<string 15> authmode [hostbased hostname <domain_name 32> hostname_IP
<ip_addr> | password | publickey]
show ssh user
authmode
Each command is listed in detail, as follows:
enable ssh
Purpose
To enable SSH.
Syntax
enable ssh
Description
The enable ssh command enables SSH on the Switch.
Parameters
None.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To enable SSH: