DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
249
sizes between the peers.
(5) OAM configuration revision: The configuration revision of the
OAM entity as reflected in the latest OAMPDU sent by the OAM
entity. The config revision is used by OAM entities to indicate that
configuration changes have occurred, which might require the peer
OAM entity to re-evaluate whether OAM peering is allowed.
(6) OAM Functions Supported: The OAM functions supported on this
port. These functions include:
Unidirectional: It indicates that the OAM entity supports the
transmission of OAMPDUs on links that are operating in
unidirectional mode (traffic flowing in one direction only).
Loopback: It indicates that the OAM entity can initiate and respond
to loop-back commands.
Link Monitoring: It indicates that the OAM entity can send and
receive Event Notification OAMPDUs.
Variable: It indicates that the OAM entity can send and receive
variable requests to monitor the attribute value as described in the
IEEE 802.3 Clause 30 MIB
At present, only unidirectional, loop-back and link monitoring are
supported.
Specifies a port, a range of ports or all ports to be displayed.
Example usage:
To show OAM control and status information of port 1:
DES-1210-52/ME:5# show ethernet_oam ports 1 status
Command: show ethernet_oam ports 1 status
Port 1
Local Client
-----------------------------------------------------------
OAM : Enabled
Mode : Active
Max OAMPDU : 1518 Bytes
Remote Loopback : Support
Unidirection : Not Supported
Link Monitoring : Support
Variable Request : Support
PDU Revision : 2
Operation Status : Disabled
Loopback Status : No Loopback
DES-1210-52/ME:5#
Used to display for Ethernet OAM configuration.
show ethernet_oam p
orts [<portlist
> |
all] configur
ation
The show ethernet_oam ports command is used to show port’s
Ethernet OAM configurations.
[<portlist> | all] − Specifies a port, a range of ports or all ports to be
To Next Page
Loading...
