D-Link DES-1210-52/ME - Layer 2 Protocol Tunneling Commands; Enable L2 Protocol_Tunnel; Disable L2 Protocol_Tunnel

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
297
39
LAYER 2 PROTOCOL TUNNELING COMMANDS
The Layer 2 Protocol Tunneling (L2PT) Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
enable
l2protocol_tunnel
disable
l2protocol_tunnel
config
l2protocol_tunnel ports
[all | <portlist>] type [uni tunneled_protocol {[stp | gvrp | protocol_mac [01-00-0C-
CC-CC-CC | 01-00-0C-CC-CC-CD] | all]} | nni | none] {threshold <value 0-
65535>}
show l2protocol_tunnel
{[nni | uni]}
Each command is listed in detail, as follows:
enable l2protocol_tunnel
Purpose
To enable the Layer 2 protocol tunneling function.
Syntax
enable l2protocol_tunnel
Description
The enable l2protocol_tunnel command is used to enable the
Layer 2 protocol tunneling function on the Switch.
Parameters
None.
Restrictions
Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To enable Layer 2 protocol tunnel of the Switch:
DES-1210-52/ME:5# enable l2protocol_tunnel
Command: enable l2protocol_tunnel
Success.
DES-1210-52/ME:5#
disable l2protocol_tunnel
Purpose
To disable the Layer 2 protocol tunneling function.
Syntax
disable l2protocol_tunnel
Description
The disable l2protocol_tunnel command is used to disable the
Layer 2 protocol tunneling function on the Switch.
Parameters
None.