D-Link DES-1210-52/ME - Config Dot1 V_Protocol_Group; Delete Dot1 V_Protocol_Group

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
219
config dot1v_protocol_group
Purpose
To add/delete a protocol to/from a protocol group.
Syntax
config dot1v_protocol_group [group_id <id 1-16> | group_name
<name 32>] [add | delete] protocol [ethernet_2 <hex 0x0-0xffff> |
ieee802.3_snap <hex 0x0-0xffff>]
Description
The config dot1v_protocol_group command adds/deletes a
protocol to/from a protocol group.The selection of a protocol can be
a pre-defined protocol type or a user specified protocol type.
Parameters
group_id <id 1-16> − The ID of protocol group which is used to
identify a set of protocols.
group_name <name 32> − The name of the protocol group. The
maximum length is 32 chars.
<hex 0x0-0xffff> − The protoocl vlaue is used to identify a protocol of
the frame type specified Depending on the frame type, the octet
string will have one of the following values: The form of the input is
0x0 to 0xffff.
Restrictions
Only Administrator and Operator and Power-User-level users can
issue this command.
Example usage:
To add a protocol IPv6 to protocol group 2:
DES-1210-52/ME:5# config dot1v_protocol_group group_id 2 add protocol
ethernet_2 0x86DD
Command: config dot1v_protocol_group group_id 2 add protocol ethernet_2
0x86DD
The protocol value configured to add will take effect on both frame types
ethernet_2 and ieee802.3_snap.
Success.
DES-1210-52/ME:5#
delete dot1v_protocol_group
Purpose
To delete a protocol group.
Syntax
delete dot1v_protocol_group [group_id <id 1-16> | group_name
<name 32> | all]
Description
The delete dot1v_protocol_group command deletes a protocol
group.
Parameters
group_id <id 1-16> − Specifies the group ID to be deleted.
group_name <name 32> − The name of the protocol group. The
maximum length is 32 characters.
Restrictions
Only Administrator and Operator and Power-User-level users can
issue this command.
Example usage:
To delete a protocol group 1: