DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
140
The show packet ports command displays statistics about packets
sent and received by ports specified in the port list. The results are
separated into three tables, labeled A, B, and C in the window
below. Table A is relevant to the size of the packets, Table B is
relevant to the type of packets and Table C is relevant to the type of
frame associated with these packets.
<portlist> − A port or range of ports whose statistics are to be
displayed.
Example usage:
To display the packets analysis for port 1:
DES-1210-52/ME:5# show packet ports 1
Command: show packet ports 1
Port Number : 1
Frame Size Frame Counts Frames/sec Frame Type Total Total/sec
---------------- -------------------- ----------------- ----------------- --------- ---------------
64 0 0 RX Bytes 0 0
65-127 0 0 RX Frames 0 0
128-255 0 0
256-511 0 0 TX Bytes 0 0
512-1023 0 0 TX Frames 0 0
1024-1518 0 0
Unicast RX 0 0
Multicast RX 0 0
Broadcast RX 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
To display the error statistics for a port or a range of ports.
show error ports <portlist>
The show error ports command displays all of the packet error
statistics collected and logged by the Switch for a given port list.
<portlist> − A port or range of ports whose error statistics are to be
displayed.
Example usage:
To display the errors of port 2:
DES-1210-52/ME:5# show errors port 1
Command: show error ports 1
To Next Page
Loading...
