D-Link DES-1210-52/ME - Delete Cos Ipv6_Mapping; Config Cos Ipv6_Tc_Mapping

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
188
Description
The show cos ipv6_mapping command is used to display the CoS
MAC mapping method on the Switch.
Parameters
<ipv6addr> - Specifies the IPv6 address to be displayed. For
example, 3000::1.
Restrictions
None.
Example usage:
To display the CoS ipv6 mapping on the Switch:
DES-1210-52/ME:5# show cos ipv6_mapping
Command: show cos ipv6_mapping
IPv6 ADDRESS Class
-------------------------------------------------
3000::1 1
DES-1210-52/ME:5#
delete cos ipv6_mapping
Purpose
To remove the CoS IPv6 mapping method.
Syntax
delete cos ipv6_mapping destination_ipv6 <ipv6addr>
Description
The delete cos ipv6_mapping command is used to delete the CoS
IPv6 mapping method on the Switch.
Parameters
<ipv6addr> - Specifies the IPv6 address to be removed.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To delete the CoS ipv6 mapping on the Switch:
DES-1210-52/ME:5# delete cos ipv6_mapping destination_ipv6 3000::1
Command: delete cos ipv6_mapping destination_ipv6 3000::1
Success.
DES-1210-52/ME:5#
config cos ipv6_tc_mapping
Purpose
To configure the CoS IPv6 TC mapping method.
Syntax
config cos ipv6_tc_mapping trafficclass <class_id 0-255> class
<class_id 0-3>
Description
The config cos ipv6_tc_mapping command is used to configure
the CoS IPv6 mapping method on the Switch.
Parameters
trafficclass <class_id 0-255>> - Specifies the IPv6 traffic class to be
mapped. The range is 0 to 255.
<class_id 0-3> - Specifies the number of the Switch’s hardware
priority queue.