D-Link DES-1210-52/ME - Show Bandwidth_Control; Config Cos Mac_Mapping

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
184
DES-1210-52/ME:5# config bandwidth_control all rx_rate 100 tx_rate
no_limit Command: config bandwidth_control all rx_rate 100 tx_rate
no_limit
Success.
DES-1210-52/ME:5#
show bandwidth_control
Purpose
To display bandwidth control settings on the Switch.
Syntax
show bandwidth control {[<portlist> | all]}
Description
The show bandwidth_control command displays bandwidth
control.
Parameters
<portlist> – A port or range of ports to be configured.
all – Specifies that the show bandwidth_control command applies
to all ports on the Switch.
Restrictions
None.
Example usage:
T o display the bandwidth control configuration:
DES-1210-52/ME:5# show bandwidth_control
Command: show bandwidth_control
Port RX Rate Tx Rate Effective Rx Effective Tx
(Kbit/sec) (Kbit/sec) (Kbit/sec) (Kbit/sec)
----- -------------- ------------- ------------------ --------------------
Total entries : 0
DES-1210-52/ME:5#
config cos mac_mapping
Purpose
To configure the CoS MAC mapping method.
Syntax
config cos mac_mapping destination_addr <macaddr> class
<class_id 0-3>
Description
The config cos mac_mapping command is used to configure the
CoS MAC mapping method on the Switch.
Parameters
<macaddr> - Specifies the MAC address to be mapped. For
example, 01:00:5E:00:00:00.
<class_id 0-3> - Specifies the number of the Switch’s hardware
priority queue.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To configure the CoS mac mapping on the Switch: