D-Link DES-1210-52/ME - Delete Link_Aggregation; Config Link_Aggregation Group_Id

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
234
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To create a link aggregation group:
DES-1210-52/ME:5# create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DES-1210-52/ME:5#
delete link_aggregation
Purpose
To delete a previously configured link aggregation group.
Syntax
delete link_aggregation group_id <value 1-8>
Description
The delete link_aggregation group_id command deletes a
previously configured link aggregation group.
Parameters
group_id <value 1-8> − Specifies the group ID. The Switch allows up
to 8 link aggregation groups to be configured. The group number
identifies each of the groups.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To delete link aggregation group:
DES-1210-52/ME:5# delete link_aggregation group_id 1
Command: delete link_aggregation group_id 1
LA channel 1 delete Successful
DES-1210-52/ME:5#
config link_aggregation group_id
Purpose
To configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-8> master_port
<port 1-52> ports <portlist>
Description
The config link_aggregation group_id command configures a link
aggregation group created with the create link_aggregation
command above.
Parameters
<value 1-8> − Specifies the group ID. The Switch allows up to 8 link
aggregation groups to be configured. The group number identifies
each of the groups.
master_port <port 1-52> − Specifies a list of ports to belong to the
link aggregation group. Ports will be listed in only one aggregation
group and link aggregation groups can not overlap to each other.
The user must cofigure at list two ports in LAG.
ports <portlist> − Specifies a list of ports to belong to the link
aggregation group.
Restrictions
Only administrator or operator-level users can issue this command.