D-Link DES-1210-52/ME - Config Address_Binding Ip_Mac Ports; Config Address_Binding Ip_Mac Log

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
65
Command: create address_binding ip_mac ipaddress 10.0.0.21
mac_address 00-00-00-00-01-02 port 3
Success.
DES-1210-52/ME:5#
config address_binding ip_mac ports
Purpose
Used to configure an IP-MAC-port binding state to enable or disable
for specified ports.
Syntax
config address_binding ip_mac ports [<portlist> | all] {state
[disable | enable] | ip_inspection [disable | enable] |
arp_inspection [loose | strict] | allow_zeroip [enable | disable] |
forward_dhcppkt [enable | disable]}
Description
The config address_binding ip_mac ports command is used to
configure the IP-MAC-port binding state to enable or disable for
specified ports.
Parameters
<portlist> − Specifies a port or range of ports.
all – Specifies all ports on the switch.
[enable | disable] – Enables or disables the specified range of ports
for state, IP-inspection, allow_zeroip and forward_dhcppkt.
arp_inspection [loose | strict] – Specifies to check the ARP
inspection to be loose or stict for the specified ports.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To configure address binding on the Switch:
DES-1210-52/ME:5# config address_binding ip_mac ports 3 state disable
arp_inspection loose ip_inspection disable
Command: config address_binding ip_mac ports 3 state disable
arp_inspection loose ip_inspection disable
Success.
DES-1210-52/ME:5#
config address_binding ip_mac log
Purpose
Used to configure an IP-MAC-port binding state to enable or disable
for specified log.
Syntax
config address_binding ip_mac log [ all | disable | ipv4 | ipv6]
Description
The config address_binding ip_mac log command is used to
configure the IP-MAC-port binding state to enable or disable for
specified log.
Parameters
[all | disable | ipv4 | ipv6] − Specifies a specified log or all log to be
configured.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To configure address binding on the Switch:
DES-1210-52/ME:5# config address_binding ip_mac log all