DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
129
17 1
CPU PROTECTION COMMANDS
The CPU Protection commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
[arp | bpdu | icmp | igmp | snmp] pps [<value> | no_limit]
Each command is listed in detail, as follows:
To enable the CPU protection function on the Switch.
The enable cpu_protect command is used to enable the CPU
protection function on the Switch.
Only Administrator or operator–level users can issue this command.
Example usage:
To enable the CPU protection function on the switch:
DES-1210-52/ME:5# enable cpu_protect
Command: enable cpu_protect
Success.
DES-1210-52/ME:5#
To disable the CPU protection function on the Switch.
The disable cpu_protect command is used to disable the CPU
protection function on the Switch.
Only Administrator or operator–level users can issue this command.
Example usage:
To disable the CPU protection function on the switch:
To Next Page
Loading...
