D-Link DES-1210-52/ME - Config Filter Dhcp_Server Log State; Show Filter Dhcp_Server; Show Dhcp_Server Screening

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
59
config filter dhcp_server log state
Purpose
To enable or disable the DHCP server log on the Switch.
Syntax
config filter dhcp_server log state [enable | disable]
Description
The config filter dhcp_server log state command is used to
enable or disable the Filter DHCP server log state.
Parameters
state [enable | disable] – Specifies that the log for the Filter DHCP
server will be enabled or disabled.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To enable the Filter DHCP Server log state:
DES-1210-52/ME:5# config filter dhcp_server log state enable
Command: config filter dhcp_server log state enable
Success.
DES-1210-52/ME:5#
show filter dhcp_server
Purpose
Used to display current DHCP server/client filter list created on the
switch.
Syntax
show filter dhcp_server
Description
The show filter dhcp_server command is used to display DHCP
server/client filter list created on the switch.
Parameters
None.
Restrictions
None.
Example usage:
To display the DHCP server filter list created on the switch:
DES-1210-52/ME:5# show filter dhcp_server
Command: show filter dhcp_server
Enabled ports :
Illegal Server Log Suppress Duration : 5 Minutes
Permit DHCP Server/Client Table:
Server IP Address Client MAC Address Ports
-------------------------- ----------------------------- ----------------
10.1.1.1 00-00-00-00-00-01 6-8
DES-1210-52/ME:5#
show dhcp_server screening
Purpose
Used to display current DHCP server screening information on the
switch.
Syntax
show dhcp_server screening