D-Link DES-1210-52/ME - Config Max_Mcast_Group; Show Max_Mcast_Group

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
295
1 (v4) Permit
3 (v4) Permit
DES-1210-52/ME:5#
config max_mcast_group
Purpose
Used to configure the maximum number of multicast groups that a
port can join.
Syntax
config max_mcast_group ports <portlist> [ipv4 | ipv6]
max_group <integer 1-512>
Description
The config max_mcast_group command is used to configure the
maximum number of multicast groups that a port can join.
Parameters
<portlist> – A range of ports to configure the maximum multicast
group.
[ipv4 | ipv6] – Specify the IPv4 or IPv6 to be configured.
max_group <integer 1-512> – Specifies the maximum number of
multicast groups. The range is from 1 to 512.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the IPv4 maximum multicast address groups on ports 1 and 3 as 100:
DES-1210-52/ME:5# config max_mcast_group ports 1,3 ipv4 max_group 100
Command: config max_mcast_group ports 1,3 ipv4 max_group 100
Success.
DES-1210-52/ME:5#
show max_mcast_group
Purpose
To display maximum multicast group ports on the Switch.
Syntax
show max_mcast_group ports <portlist> {[ipv4 | ipv6]}
Description
The show max_mcast_group command displays the multicast
filtering profiles settings.
Parameters
<portlist> - Specify a port or range of ports to be displayed.
{[ipv4 | ipv6]} – Specify the IPv4 or IPv6 to be displayed.
Restrictions
None.
Example usage:
To show IPv6 maximum multicast group port 1 and 3 settings:
DES-1210-52/ME:5# show max_mcast_group ports 1,3 ipv6
Command: show max_mcast_group ports 1,3 ipv6
Port Max Group
----- --------------------
1 (v6) 256
3 (v6) 256