D-Link DES-1210-52/ME - Config Address_Binding Dhcp_Snoop Max_Entry Ports; Show Address_Binding Dhcp_Snoop

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
70
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To disable the DHCP snooping of address binding for port 3~5 on the Switch:
DES-1210-52/ME:5# disable address_binding dhcp_snoop ports 4
Command: disable address_binding dhcp_snoop ports 4
Success.
DES-1210-52/ME:5#
config address_binding dhcp_snoop max_entry ports
Purpose
Used to specify the maximum number of entries which can be
dynamically learned (DHCP snooping) by the specified ports.
Syntax
config address_binding dhcp_snoop max_entry ports
[<portlist> | all] limit [<int 1-10> | no_limit] {IPv6}
Description
This config address_binding dhcp_snoop max_entry ports
command is used to specify the maximum number of DHCP
snooping entries on specified ports. By default, the per-port
maximum entry has no limit.
Parameters
[<portlist> | all] – Specifies a port, a range of ports or all ports to be
configured of the address binding DHCP snooping on the Switch.
[<int 1-10> | no_limit] – Specifies the limit for max entry number.
{IPv6} – Specifies the IPv6 address used for this configuration.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To configure the DHCP snooping of address binding for port 1 on the Switch:
DES-1210-52/ME:5# config address_binding dhcp_snoop max_entry
ports 1 limit 1
Command: config address_binding dhcp_snoop max_entry ports 1
limit 1
Success.
DES-1210-52/ME:5#
show address_binding dhcp_snoop
Purpose
Used to display DHCP snoop of IP-MAC-port binding.
Syntax
show address_binding dhcp_snoop [binding_entry | max_entry
| vlan_list] port <portlist>
Description
This show address_binding dhcp_snoop command is used to
display DHCP snoop of IP-MAC-port binding entries. Two different
kinds of information can be viewed. They are binding entry and max
entry.
[binding_entry | max_entry | vlan_list] – Address binding entries can
be viewed by entering the physical and IP addresses of the device.
port – The number of enabled ports on the device to be displayed.
Parameters
[binding_entry | max_entry | vlan_list] – Specifies address binding
entries can be viewed