D-Link DES-1210-52/ME - Config Filter Dhcpv6_Server Log State; Show Filter Dhcpv6_Server

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
62
Success.
DES-1210-52/ME:5#
config filter dhcpv6_server log state
Purpose
To enable or disable the DHCPv6 server log on the Switch.
Syntax
config filter dhcpv6_server log state [enable | disable]
Description
The config filter dhcpv6_server log state command is used to
enable or disable the Filter DHCPv6 server log state.
Parameters
state [enable | disable] – Specifies that the log for the Filter DHCPv6
server will be enabled or disabled.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To enable the Filter DHCPv6 Server log state:
DES-1210-52/ME:5# config filter dhcpv6_server log state enable
Command: config filter dhcpv6_server log state enable
Success.
DES-1210-52/ME:5#
show filter dhcpv6_server
Purpose
Used to display the filter DHCPv6 server information on the switch.
Syntax
show filter dhcpv6_server
Description
The show filter dhcpv6_server command is used to display the
filter DHCPv6 server information on the switch.
Parameters
None.
Restrictions
None.
Example usage:
To display the filter DHCPv6 server information on the switch:
DES-1210-52/ME:5# show filter dhcpv6_server
Command: show filter dhcpv6_server
Enabled ports : 2-5
DHCPv6 Filter Syslog State : Enable
Success.
DES-1210-52/ME:5#