DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
226
To to enable auto assignment of PVID.
The enable pvid auto_assign command enables the auto-assign of
PVID. When this is enabled, PVID will be possibly changed by PVID
or VLAN configuration. When user configures a port to VLAN X’s
untagged membership, this port’s PVID will be updated with VLAN
X. In the form of VLAN list command, PVID is updated with last item
of VLAN list. When user removes a port from the untagged
membership of the PVID’s VLAN, the port’s PVID will be assigned
with “default VLAN”. The default setting is enabled.
Only Administrator, Operator and Power-User-level users can issue
this command.
Example usage:
To enable the auto-assign PVID:
DES-1210-52/ME:5# enable pvid auto_assign
Command: enable pvid auto_assign
Success.
DES-1210-52/ME:5#
To to disable auto assignment of PVID.
The disable pvid auto_assign command disables the auto-assign
of PVID. When it is disabled, PVID only be changed by PVID
configuration (user changes explicitly). The VLAN configuration will
not automatically change PVID. The default setting is enabled.
Only Administrator, Operator and Power-User-level users can issue
this command.
Example usage:
To disable the auto-assign PVID:
DES-1210-52/ME:5# disable pvid auto_assign
Command: disable pvid auto_assign
Success.
DES-1210-52/ME:5#
To to show auto assignment of PVID.
The show pvid auto_assign command is used to show PVID auto-
assigment state.
To Next Page
Loading...
