D-Link DES-1210-52/ME - Enable Gvrp; Disable Gvrp; Show Vlan

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
217
Success.
DES-1210-52/ME:5#
enable gvrp
Purpose
To enable GVRP on the Switch.
Syntax
enable gvrp
Description
The enable gvrp command, along with the disable gvrp command
below, is used to enable and disable GVRP on the Switch, without
changing the GVRP configuration on the ports and the LAGs.
Parameters
None.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DES-1210-52/ME:5# enable gvrp
Command: enable gvrp
Success.
DES-1210-52/ME:5#
disable gvrp
Purpose
To disable GVRP on the Switch.
Syntax
disable gvrp
Description
The disable gvrp command, along with the enable gvrp command
above, is used to enable and disable GVRP on the Switch, without
changing the GVRP configuration on the ports and the LAGs.
Parameters
None.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To disable the Generic VLAN Registration Protocol (GVRP):
DES-1210-52/ME:5# disable gvrp
Command: disable gvrp
Success.
DES-1210-52/ME:5#
show vlan
Purpose
To display the current VLAN configuration on the Switch
Syntax
show vlan {<vlan_name 32> | vlanid <vidlist> | ports <portlist>}
Description
The show vlan command displays summary information about each
VLAN including the VLAN ID, VLAN name, the Tagging/Untagging
status, and the Member/Non-member/Forbidden status of each port
that is a member of the VLAN.