D-Link DES-1210-52/ME - Config L2 Protocol_Tunnel; Show L2 Protocol_Tunnel

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
298
Restrictions
Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To disable Layer 2 protocol tunnel of the Switch:
DES-1210-52/ME:5# disable l2protocol_tunnel
Command: disable l2protocol_tunnel
Success.
DES-1210-52/ME:5#
config l2protocol_tunnel
Purpose
To configure Layer 2 protocol tunneling on ports.
Syntax
config l2protocol_tunnel ports [all | <portlist>] type [uni
tunneled_protocol {[stp | gvrp | protocol_mac [01-00-0C-CC-CC-
CC | 01-00-0C-CC-CC-CD] | all]} | nni | none] {threshold <value
0-65535>}
Description
The show l2protocol_tunnel command is used to configure Layer
2 protocol tunneling on ports on the Switch.
Parameters
[all | <portlist>] – Specify a list of ports or all ports on which the
Layer 2 protocol tunneling to be configured.
uni - Specify the ports as UNI ports 2.
tunneled_protocol - Specify tunneled protocols on the UNI ports.
STP –Specify to use the STP protocol
Gvrp –Specify to use the GVRP protocol
protocol_mac - Specify the destination MAC address of the L2
protocol packets that will tunneled on these UNI ports.
nni - Specify the ports as NNI ports
threshold <value 0-65535> - Specify the drop threshold for packets-
per-second accepted on theUNI ports. The ports drop the PDU if the
protocol’s threshold is exceeded.
Restrictions
None.
Example usage:
To configure Layer 2 protocol tunnel of the Switch:
DES-1210-52/ME:5# config l2protocol_tunnel ports 6-8 type nni
Command: config l2protocol_tunnel ports 6-8 type nni
Success.
DES-1210-52/ME:5#
show l2protocol_tunnel
Purpose
To display the Layer 2 protocol tunneling function.
Syntax
show l2protocol_tunnel {[nni | uni]}
Description
The show l2protocol_tunnel command is used to display the Layer