D-Link DES-1210-52/ME - Upload

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
109
file, up to 64 characters, on the TFTP server. For example, C:\ DES-
1210-52ME-C1-20-01-B052-ALL.hex.
image_id <value 1-2> − Specify the image id to be download.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To download a firmware file:
DES-1210-52/ME:5# download firmware_fromTFTP 172.21.45.73 DES-
1210-52ME-C1-20-01-B054-ALL.hex image_id 1
Command: download firmware_fromTFTP 172.21.45.73 DES-1210-52ME-
C1-20-01-B054-ALL.hex image_id 1
Connecting to server…………………..Done.
Download firmware………………..…..Done. Do not power off!
Please wait, programming flash……Done.
Success.
Image Updated Successful
DES-1210-52/ME:5#
To download a configuration file:
DES-1210-52/ME:5# download configuration 10.48.74.121 c:\cfg\setting.txt
Overwrite file [startup-config] ?[Yes/press any key for no]....
01-Jan-200003:19:46%COPY-I-FILECPY:FilesCopy-source URL tftp://10.48.74.121/1.txt
destination
URL flash://startup-config
Success.
Success.
.....01-Jan-2000 03:18:40 %COPY-N-TRAP: The copy operation was completed
Success.fully!
Copy: 267 bytes copied in 00:00:08 [hh:mm:ss]
DES-1210-52/ME:5#
upload
Purpose
To upload the current switch settings to a TFTP server.
Syntax
upload [[firmware_toTFTP [<ipaddr> | <ipv6_addr>]
<path_filename 64> image_id <value 1-2>] | [cfg_toTFTP
[<ipaddr> | <ipv6_addr>] <path_filename 64> config_id <value
1-2>] | [log_toTFTP [<ipaddr> | <ipv6_addr>] <path_filename
64>]]
Description
The upload command uploads the Switch’s current settings to a
TFTP server.
Parameters
firmware_toTFTP − Specifies that the Switch’s current firmware are
to be uploaded to the TFTP server.
<ipaddr> − The IPv4 address of the TFTP server. The TFTP server