D-Link DES-1210-52/ME - Clear Mld_Snooping Data_Driven_Group; Show Mld_Snooping

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
286
Example usage:
To enable the data driven learning of an MLD snooping group on the default VLAN:
DES-1210-52/ME:5# config mld_snooping data_driven_learning vlan_name
default state enable
Command: config mld_snooping data_driven_learning vlan_name default state
enable
Success. !
DES-1210-52/ME:5#
clear mld_snooping data_driven_group
Purpose
To clear the mld snooping data driven group on the Switch.
Syntax
clear mld_snooping data_driven_group [vlan_name <string 32>
| vlanid <vidlist> | all] {<ipv6_addr> | all}
Description
The clear mld_snooping data_driven_group command used to
clear the mld snooping data driven group on the Switch.
Parameters
vlan_name <string 32> – Clear that the mld snooping applies only to
this previously created VLAN.
vlanid <vidlist> – Clear that the mld snooping applies only to this
previously created VLAN id.
all – Clear that MLD snooping is to be configured for all VLANs on
the Switch.
{<ipv6_addr> | al}l – Specifies the IPv6 address or all of mld
snooping data driven group to be removed.
Restrictions
Only administrator–level users can issue this command.
Example usage:
To clear MLD snooping data driven group:
DES-1210-52/ME:5# clear mld_snooping data_driven_group vlan_name 2 3000::1
Command: clear mld_snooping data_driven_group vlan_name 2 3000::1
Success. !
DES-1210-52/ME:5#
show mld_snooping
Purpose
To display mld snooping settings on the Switch.
Syntax
show mld_snooping [vlan_name <string 32> | vlanid <vidlist> |
all]
Description
The show mld snooping command displays a port from being
defined as a multicast router port by static configuration or by
automatic learning.
Parameters
vlan_name <string 32> – Displays that the mld snooping applies
only to this previously created VLAN.
vlanid <vidlist> – Displays that the mld snooping applies only to this
previously created VLAN id.