D-Link DES-1210-52/ME - Config Dhcp_Local_Relay Port; Config Dhcp_Local_Relay Vlan

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
122
Parameters
None.
Restrictions
Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To disable the DHCP Local Relay:
DES-1210-52/ME:5# disable dhcp_local_relay
Command: disable dhcp_local_relay
Success.
DES-1210-52/ME:5#
config dhcp_local_relay port
Purpose
To enable or disable the ports of DHCP Local Relay.
Syntax
config dhcp_local_relay port <portlist> state [enable | disable]
Description
The config dhcp_local_relay port command is used to enable or
disable the ports of DHCP Local Relay.
Parameters
<portlist> – Specifies the ports to be enabled or disabled.
state [enable | disable] – Enable or disable the specified ports of the
DHCP Local Relay status.
Restrictions
Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To enable the port 8-10 of DHCP Local Relay:
DES-1210-52/ME:5# config dhcp_local_relay port 8-10 state enable
Command: config dhcp_local_relay port 8-10 state enable
Success.
DES-1210-52/ME:5#
config dhcp_local_relay vlan
Purpose
To specify which VLAN’s the feature works on.
Syntax
config dhcp_local_relay vlan [<vlan_name 32> | vlanid <vidlist>]
state [enable | disable]
Description
Each VLAN which was added to the DHCP Local Relay list
participates in the DHCP Local Relay process – Option 82 is added
to DHCP requests on this VLAN, and Removed from DHCP Replies
on this VLAN.
Parameters
[<vlan_name 32> | vlanid <vidlist>] – Specify the vlan name or vlan
id to be configured.
state [enable | disable] – enable or disable of the DHCP Local Relay