D-Link DES-1210-52/ME - Config Cpu_Protect Type; Show Cpu_Protect

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
130
DES-1210-52/ME:5# disable cpu_protect
Command: disable cpu_protect
Success.
DES-1210-52/ME:5#
config cpu_protect type
Purpose
To configure the CPU protection packet type on the Switch.
Syntax
config cpu_protect type [arp | bpdu | icmp | igmp | snmp] pps
[<value> | no_limit]
Description
The config cpu_protect type command is used to configure the
CPU protection packet type on the Switch.
Parameters
[arp | bpdu | icmp | snmp] – Specifies the packet type of CPU
protection to be configured.
[<value> | no_limit] – Specifies the maximum packet number can be
up to CPU.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the CPU protection with ARP type on the switch:
DES-1210-52/ME:5# config cpu_protect type arp pps no_limit
Command: config cpu_protect type arp pps no_limit
Success.
DES-1210-52/ME:5#
show cpu_protect
Purpose
To display the CPU protection information on the Switch.
Syntax
show cpu_protect
Description
The show cpu_protect command is used to display the CPU
protection information on the Switch.
Parameters
None.
Restrictions
None.
Example usage:
To display the CPU protection information on the switch: