DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
215
To remove a vlan which VLAN ID is 2:
DES-1210-52/ME:5# delete vlan vlanid 2
Command: delete vlan vlanid 2
Success.
DES-1210-52/ME:5#
To add additional ports to a previously configured VLAN and to
modify a VLAN name.
config vlan [<vlan_name 32> | vlanid <vlanid 1-4094>] [[add
[tagged
|
untagged
|
forbidd
en]
|
delete
] [<portlist>
|
name
<vlan_name 32>] {advertisement [enable | disable]}
The config vlan command allows the user to add or delete ports to
the port list of a previously configured VLAN. You can specify the
additional ports as tagging, untagging, or forbidden. The default is to
assign the ports as untagged.
<vlan_name 32> − The name of the VLAN to be configure.
vlanid <vidlist> − The ID of the VLAN to which to add ports.
add − Specifies that ports are to be added to a previously created
vlan.
delete - Specifies that ports are to be deleted from a previously
created vlan.
tagged − Specifies the additional ports as tagged.
untagged − Specifies the additional ports as untagged.
forbidden − Specifies the additional ports as forbidden.
<portlist> − A port or range of ports to be added to or deleted from
the VLAN.
name <vlan_name 32> − Enter the vlan name for the specified vlan
id.
advertisement [enable | disable] − Specifies that the vlan
advertisement is enabled or disabled.
Only administrator or operator-level users can issue this command.
Example usage:
To add ports 4 through 8 as tagged ports to the VLAN 3:
DES-1210-52/ME:5# config vlan vlanid 3 add tagged 4-8
Command: config vlan vlanid 3 add tagged 4-8
Success.
DES-1210-52/ME:5#
To configure configures the Group VLAN Registration Protocol on
the Switch. The user can configure ingress checking and acceptable
frame tagged only, the sending and receiving of GVRP information,
and the Port VLAN ID (PVID).
config gvrp [<portlist> | all] [state [enable | disable] |
To Next Page
Loading...
