D-Link DES-1210-52/ME - Show Address_Binding Ip_Mac Log; Config Address_Binding Auto_Scan; Config Address_Binding Auto_Scan Ipv6 Address

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
66
Command: config address_binding ip_mac log all
Success.
DES-1210-52/ME:5#
show address_binding ip_mac log
Purpose
Used to display an IP-MAC-port binding IP MAC log information.
Syntax
show address_binding ip_mac log
Description
The show address_binding ip_mac log command is used to
display an IP-MAC-port binding IP MAC log information.
Parameters
None.
Restrictions
None.
Example usage:
To display address binding IP MAC log information on the Switch:
DGS-1210-28P/ME:5# show address_binding ip_mac log
Command: show address_binding ip_mac log
Log status: IPv4
DGS-1210-28P/ME:5#
config address_binding auto_scan
Purpose
Used to configure an IP-MAC-port binding auto scan for specified IP
addresses.
Syntax
config address_binding auto_scan from_ip <ipaddr> to_ip
<ipaddr>
Description
The config address_binding auto_scan command is used to
configure the IP-MAC-port binding auto scan for specified IP
addresses.
Parameters
<ipaddr> − Specifies a range of IP addresses for address binding
auto scan on the Switch.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To configure address binding auto scan on the Switch:
DES-1210-52/ME:5# config address_binding auto_scan from_ip 10.0.0.10
to_ip 10.0.0.12
Command: config address_binding auto_scan from_ip 10.0.0.10 to_ip
10.0.0.12
Success.
DES-1210-52/ME:5#
config address_binding auto_scan ipv6address
Purpose
Used to configure an IP-MAC-port binding auto scan for specified