D-Link DES-1210-52/ME - Lldp Commands

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
381
54
LLDP COMMANDS
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable lldp
disable lldp
config lldp
message_tx_interval
<sec 5-32768>
config lldp
message_tx_hold_multiplier
<int 2-10>
config lldp reinit_delay
<sec 1-10>
config lldp tx_delay
<sec 1-8192>
config lldp
notification_interval
<sec 5-3600>
show lldp
show lldp ports
{<portlist>}
show lldp local_ports
{<portlist>} {mode[brief | normal | detailed]}
show lldp remote_ports
{<portlist>} {mode[brief | normal | detailed]}
config lldp ports
[<portlist> | all] notification [enable | disable]
config lldp ports
[<portlist> | all] admin_status [tx_only | rx_only | tx_and_rx | disable]
config lldp ports
[<portlist>|all] mgt_addr [ipv4 <ipaddr>| ipv6 <ipv6addr>] [enable | disable]
config lldp ports
[<portlist>|all] basic_tlvs [all | {port_description | system_name |
system_description | system_capabilities}] [enable | disable]
config lldp ports
[<portlist>|all] dot3_tlvs [all | link aggregation | mac_phy_configuration_status
| maximum_frame_size | power_via_mdi] [enable | disable]
config lldp ports
[<portlist>|all] dot1_tlv_pvid [disable | enable]
config lldp ports
[<portlist>|all] dot1_tlv_protocol_identity [all | eapol | gvrp | lacp | stp][disable
| enable]
config lldp ports
[<portlist>|all] dot1_tlv_vlan_name [vlan <vlan_name 32> | vlanid <vidlist>]
[disable | enable]
config lldp ports
[<portlist>|all] power_pse_tlv [enable | disable]
show lldp power_pse_tlv
show lldp mgt_addr
{ipv4 <ipaddr> | ipv6 <ipv6addr>}
show lldp statistics
{ports <portlist>}