D-Link DES-1210-52/ME - Config Lldp Tx_Delay; Config Lldp Notification_Interval; Show Lldp

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
384
config lldp tx_delay
Purpose
To configure the lldp tx_delay on the switch.
Syntax
config lldp tx_delay <sec 1-8192>
Description
The config lldp tx_delay command specifies the delay between
Success.ive LLDP frame transmissions initiated by value/status
changes in the LLDP local systems MIB, use the lldp tx_delay
command in global configuration mode.
Parameters
<sec 1-8192> – Specifies the minimum time in seconds an LLDP
port will wait before reinitializing LLDP transmission. The range is
1 – 8192 seconds. The default configuration is 2 seconds.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP tx delay:
DES-1210-52/ME:5# config lldp tx_delay 1
Command: config lldp tx_delay 1
Success.
DES-1210-52/ME:5#
config lldp notification_interval
Purpose
To configure the timer of the notification interval used to send
notifications to configured SNMP trap receiver(s).
Syntax
config lldp notification_interval <sec 5-3600>
Description
The config lldp notification_interval command globally changes
the interval between Success.ive LLDP change notifications
generated by the switch.
Parameters
<sec 5-3600> – The range is from 5 second to 3600 seconds. The
default setting is 5 seconds.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To change the notification interval:
DES-1210-52/ME:5# config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DES-1210-52/ME:5#
show lldp
Purpose
To display the Link Layer Discovery Protocol (LLDP) on the switch.
Syntax
show lldp
Description
The show lldp displays the LLDP configuration on the switch.