DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
32
To display system and configuration information. to provide to the
Technical Assistance Center when reporting a problem, use the
show tech-support command.
The show tech support command displays system and
configuration information. to provide to the Technical Assistance
Center when reporting a problem.
By default, this command displays the output for technical-support-
related show commands. Use keywords to specify the type of
information to be displayed. If you do not specify any parameters,
the system displays all configuration and memory data.
The show tech support command may time out if the configuration
file output takes longer to display than the configured session
timeout time. If this happens, enter a set logout timeout value of 0 to
disable automatic disconnection of idle sessions or enter a longer
timeout value.
The show tech support command output is continuous; it does not
display one screen at a time. To interrupt the output, press Esc.
Example usage:
To display technical support information on the Switch:
DES-1210-52/ME:5# show tech support
Command: show tech support
- Stacktrace Log -
No stacktrace information.
- System Info. -
Device Type : DES-1210-52/ME
MAC Address : 00-01-02-03-04-05
IP Address : 10.90.90.90 (Manual)
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
System Boot Version : 1.00.010
System Firmware Version : 20.01.B045
System Hardware Version : C1
System Serial Number : QBDES12105200
System Name :
System Location :
System up time : 0 days, 0 hrs, 34 min, 56 secs
System Contact :
System Time : 01/01/2014 00:34:44
To Next Page
Loading...
