D-Link DES-1210-52/ME - Show Port Dot1 V

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
221
group_id <id 1-16> − The ID of protocol group which is used to
identify a set of protocols.
<vlan_name 32> − Specify the VLAN name to be configured.
<id 1-4094> − Specify the VLAN id to be configured.
Restrictions
Only Administrator and Operator and Power-User-level users can
issue this command.
Example usage:
To configure the group ID 4 to be associated with VLAN 2:
DES-1210-52/ME:5# config port dot1v ports all add protocol_group group_id
4 vlan vlan2
Command: config port dot1v ports all add protocol_group group_id 4 vlan
vlan2
Success.
DES-1210-52/ME:5#
show port dot1v
Purpose
To display the VLAN to be associated with untagged packets
ingressed from a port based on the protocol group.
Syntax
show port dot1v {ports <portlist>}
Description
The show port dot1v command is used to display the VLAN to be
associated with untagged packets ingressed from a port based on
the protocol group.
Parameters
ports <portlist> − Specify a range of ports to be displayed. If not
specified, information for all ports will be displayed.
Restrictions
None.
Example usage:
To display the protocol VLAN information for ports 1 to 2:
DES-1210-52/ME:5# show port dot1v ports 1-2
Command: show port dot1v ports 1-2
Port: 1
No valid dot1v entry!
Port: 2
No valid dot1v entry!
Total Entries: 0
DES-1210-52/ME:5#