D-Link DES-1210-52/ME - Config Radius Add

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
307
ports <portlist> – A port or range of ports to be re-authorized.
all – Specifies all of the ports on the Switch.
Restrictions
Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To configure 802.1x reauthentication for ports 1-18:
DES-1210-52/ME:5# config 802.1x reauth port_based ports 1-18
Command: config 802.1x reauth port_based ports 1-18
Success.
DES-1210-52/ME:5#
config radius add
Purpose
To configure the settings the Switch uses to communicate with a
RADIUS server.
Syntax
config radius add <server_index 1-3> [<ipaddr> | <ipv6_addr>]
[key <passwd 32>] {default | auth_port <udp_port_number 1-
65535> | acct_port <udp_port_number 1-65535> | retransmit
<int 1-255> | timeout <int 1-255>}
Description
The config radius add command configures the settings the Switch
uses to communicate with a RADIUS server.
Parameters
<server_index 1-3> – The index of the RADIUS server.
[<ipaddr> | <ipv6_addr]> – The IPv4 or IPv6 address of the RADIUS
server.
key – Specifies that a password and encryption key are to be used
between the Switch and the RADIUS server.
<passwd 32> – The shared-secret key used by the RADIUS server
and the Switch. Up to 128 characters can be used.
default – Uses the default udp port number in both the auth_port and
acct_port settings.
auth_port <udp_port_number 1-65535> – The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> – The UDP port number for
accounting requests. The default is 1813.
retransmit <int 1-255> – The number of times the device resends an
authentication request when the server does not respond. The value
is between 1 and 255.
timeout <int 1-255> – Specifies the connection timeout. The value
may be between 1 and 255 seconds.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the RADIUS server communication settings:
DES-1210-52/ME:5# config radius add 1 10.48.47.11 key dlink default
Command: config radius add 1 10.48.47.11 key dlink default