D-Link DES-1210-52/ME - Enable Snmp Traps; Disable Snmp Traps

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
94
To delete a trusted host with an IPv4 address 10.90.90.91:
DES-1210-52/ME:5# delete trusted_host 10.90.90.91
Command: delete trusted_host 10.90.90.91
Success.
DES-1210-52/ME:5#
To delete a trusted host with an IPv6 address 3000::1:
DES-1210-52/ME:5# delete trusted_host 3000::1
Command: delete trusted_host 3000::1
Success.
DES-1210-52/ME:5#
enable snmp traps
Purpose
To enable SNMP trap support.
Syntax
enable snmp traps
Description
The enable snmp traps command enables SNMP trap support on
the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command
Example usage:
To enable SNMP trap support on the Switch:
DES-1210-52/ME:5# enable snmp traps
Command: enable snmp traps
Success.
DES-1210-52/ME:5#
disable snmp traps
Purpose
To disable SNMP trap support on the Switch.
Syntax
disable snmp traps
Description
The disable snmp traps command disables SNMP trap support on
the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To prevent SNMP traps from being sent from the Switch:
DES-1210-52/ME:5# disable snmp traps
Command: disable snmp traps
Success.