DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
411
57
SAFEGUARD COMMANDS
The Safeguard commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Each command is listed in detail, as follows:
To define the safeguard engine on the switch.
config safeguard_engine state [enable | disable]
To define the safeguard_engine on the switch.
state [enable | disable] – enable and disable Safeguard engine on
the Switch.
Only Administrator or operator-level users can issue this command.
Example usage:
To enable the safeguard engine on the switch:
DES-1210-52/ME:5# config safeguard_engine state enable
Command: config safeguard_engine state enable
Success.
DES-1210-52/ME:5#
To show the safeguard engine status on the switch.
To show the safeguard engine on the switch.
Only Administrator or operator-level users can issue this command.
Example usage:
To Next Page
Loading...
