DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
262
add 10.90.90.93 10.90.90.95
Success.
DES-1210-52/ME:5#
create igmp_snooping static_group
To create an IGMP snooping static group on the Switch.
create igmp_snooping static_group [vlan <vlan_name 32> |
vlanid <vlanid_list>] <ipaddr>
The create igmp_snooping static_group command allows you to
create an IGMP snooping static group. Member ports can be added
to the static group. The static member and the dynamic member port
from the member ports of a group.
The statis group will only take effect when IGMP snooping is
enabled on the VLAN. For those statis member ports, the device
needs to emulate the IGMP protocol operation to the querier, and
forward the traffic destined to the multicast group to the member
ports.
<vlan_name 32> − The name of the VLAN for which IGMP snooping
statis group is to be created. Up to 32 characters can be used.
<vlanid_list> − The ID of the VLAN for which IGMP snooping static
group is to be created. The range is from 2 to 4094.
<ipaddr> − Specify the static group address for which IGMP
snooping to be created.
Only administrator or operator-level users can issue this command.
Example usage:
To create a igmp snooping static group 226.1.1.1 for VID 1:
DES-1210-52/ME:5# create igmp_snooping static_group vlanid 1 226.1.1.1
Command: create igmp_snooping static_group vlanid 1 226.1.1.1
Success.
DES-1210-52/ME:5#
config igmp_snooping static_group
To configure the current IGMP snooping static group on the Switch.
config igmp_snooping static_group [vlan <vlan_name 32> |
vlanid <vlanid_list>] <
ipaddr> [add | delete] <portlist>
The config igmp_snooping static_group command is used to add
or delete ports to /from the given static group.
<vlan_name 32> − The name of the VLAN for which IGMP snooping
static group is to be configured. Up to 32 characters can be used.
[add | delete] − Specify whether to add or delete ports defined in the
To Next Page
Loading...
