D-Link DES-1210-52/ME - Spanning Tree Commands; Config Stp

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
153
21
SPANNING TREE COMMANDS
The Spanning Tree commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config stp
{maxage <value 6-40> | hellotime <value 1-10> | forwarddelay <value 4-30>|
txholdcount <value 1-10>}
config stp ports
<portlist> {externalcost [auto | <value 1-200000000>] | edge [auto | true | false] |
hellotime <value 1-2> | p2p [true | false | auto ] | state [enable | disable] | fbpdu
[enable | disable] | migrate [yes | no] | priority <value 0-240> | restricted_role [true
| false] | restricted_tcn [true | false] }
config stp version
[mstp | rstp | stp]
config stp fbpdu
[enable | disable]
config stp priority
<value 0-61440> instance_id <value 0-63>
enable stp
disable stp
show stp
show stp ports
{<portlist>}
show stp instance
<value 0-63>}
show stp mst_config_id
create stp instance_id
<value 1-63>
delete stp instance_id
<value 1-63>
config stp instance_id
<value 1-63> [add_vlan | remove_vlan] <vidlist>
config stp
mst_config_id
[revision_level <int 0-65535> | name <string 32>]
config stp mst_ports
<portlist> instance_id <value 0-63> {internalCost [auto | value 1-200000000] |
priority <value 0-240>}
config stp trap
{new_root [enable | disable] | topo_change [enable | disable]}
Each command is listed in detail, as follows:
config stp
Purpose
To setup STP, RSTP and MSTP on the Switch.
Syntax
config stp {maxage <value 6-40> | hellotime <value 1-10> |
forwarddelay <value 4-30>| txholdcount <value 1-10>}
Description
The config stp command configures the Spanning Tree Protocol
(STP) for the entire switch. All commands here are implemented for