DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
229
To disable the Q-in-Q mode.
The disable qinq command creates a used to disable the Q-in-Q
mode.
All dynamically learned L2 address will be cleared. All dynamically
registered VLAN entries will be cleared, GVRP will be disabled.
If you need to run GVRP on the Switch, firstly enable GVRP
manually. All existing SP-VLANs will run as static 1Q VLANs. The
default setting of Q-in-Q is disabled.
Only administrator or operator-level users can issue this command.
Example usage:
To disable Q-in-Q:
DES-1210-52/ME:5# disable qinq
Command: disable qinq
Success.
DES-1210-52/ME:5#
To show global Q-in-Q and port Q-in-Q mode status.
show qinq
{ports <portlist> | inner_tpid
}
The show qinq command is used to show the global Q-in-Q status,
including: port role in Q-in-Q mode and port outer TPID.
<portlist> - Specifies a range of ports to be displayed.
If no parameter is specified, the system will display all Q-in-Q port
information.
inner_tpid - Specifieyed.
Example usage:
To show the Q-in-Q status for ports 1:
DES-1210-52/ME:5# show qinq ports 1
Command: show qinq ports 1
Port ID: 1
---------------------------------------------------------
Role: UNI
Outer Tpid: 0x8100
Vlan Translation State: Disabled
---------------------------------------------------------
To Next Page
Loading...
