D-Link DES-1210-52/ME - Mld Snooping Commands

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
277
37
MLD SNOOPING COMMANDS
The MLD Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable mld_snooping
{multicast_vlan | forward_mcrouter_only}
disable mld_snooping
{multicast_vlan | forward_mcrouter_only}
config mld_snooping
[vlan_name <string 32> | vlanid <vidlist> | all] {fast_done [enable | disable] |
host_timeout <sec 130-1530255> | leave_timer <sec 1-25> | router_timeout <sec
60-600> | state [enable | disable] | report_suppression [enable | disable]}
create mld_snooping
multicast_vlan
<vlan_name 32> <vlanid 2-4094>
config mld_snooping
multicast_vlan
<vlan_name 32> {[add | delete] [member_port <portlist> | [source_port <portlist>
| untag_source_port <portlist>] | tag_member_port <portlist>] | state [enable |
disable] | replace_source_ipv6 <ipv6addr> | remap_priority [<value 0-7> | none]
{ replace_priority}}
show mld_snooping
multicast_vlan
<vlan_name 32>
delete mld_snooping
multicast_vlan
[<vlan_name 32> | all]
config mld_snooping
multicast_vlan_group
<vlan_name 32>
[add | delete] ipv6_range <ipv6addr> <ipv6addr>
show mld_snooping
multicast_vlan_group
{<vlan_name 32>}
config mld_snooping
mrouter_ports
[vlan_name <string 32> | vlanid <vidlist> | all] [add | delete] <portlist>
config mld_snooping
mrouter_port_forbidden
[vlan_name <string 32> | vlanid <vidlist> | all] [add | delete] <portlist>
config mld_snooping
querier
[vlan_name <string 32> | vlanid <vidlist> | all] [last_listener_query_interval <sec
1-25> | max_response_time <sec 10-25> | query_interval <sec 60-600> |
robustness_variable | state [enable | disable] | version <value 1-2>]
config mld_snooping
data_driven_learning
[max_learned_entry <value 1-256>| vlan_name <string 32> | vlanid <vidlist> | all]
[age_out [disable | enable] | expiry_time <sec 130-1530255> | state [enable |
disable]]
clear mld_snooping
data_driven_group
[vlan_name <string> | vlanid <vidlist> | all] {<ipv6_addr> | all}
show mld snooping
[vlan_name <string 32> | vlanid <vidlist> | all]
show mld_snooping
forwarding
[vlan_name <string 32> | vlanid <vidlist> | all]
show mld_snooping
group
[vlan_name <string 32> | vlanid <vidlist> | all | ports <portlist>]