D-Link DES-1210-52/ME - Rmon Commands; Enable Rmon

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
203
26
RMON COMMANDS
The RMON commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable rmon
disable rmon
create rmon alarm
<alarm_index 1-65535> <OID_variable 255> <interval 1-2147482647> [absolute
| delta] rising-threshold <value 0-2147483647> <rising_event_index 1-65535>
falling-threshold <value 0-2147483647> <falling_event_index 1-65535> {[owner
<owner_string 32>]}
delete rmon alarm
<alarm_index 1-65535>
create rmon collection
stats
<stats_index 1-65535> port <ifindex> owner <owner_string 32>
delete rmon collection
stats
<stats_index 1-65535>
create rmon collection
history
<hist_index 1-65535> port <ifindex> {buckets <buckets_req 1-50> interval
<interval 1-3600> owner <owner_string 32>}
delete rmon collection
history
<hist_index 1-65535>
create rmon event
<event_index 1-65535> description <desc_string 128> {[log | owner
<owner_string 32> | trap <community_string 32>]}
delete rmon event
<event_index 1-65535>
show rmon
show rmon statistics
{<stats_index 1-65535>}
Each command is listed in detail, as follows:
enable rmon
Purpose
To enable remote monitoring (RMON) status for the SNMP function.
Syntax
enable rmon
Description
The enable rmon command enables remote monitoring (RMON)
status for the SNMP function on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable the RMON feature on the Switch:
DES-1210-52/ME:5# enable rmon