D-Link DES-1210-52/ME - Create Trusted_Host

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
92
Restrictions
Only administrator or operator level users can issue this command.
Example usage:
To disable the trusted host on the Swtich:
DES-1210-52/ME:5# disable trusted_host
Command: disable trusted_host
Success.
DES-1210-52/ME:5#
create trusted_host
Purpose
To create a trusted host.
Syntax
create trusted_host [<ipaddr> | network <network_address> |
<ipv6_addr> | ipv6_prefix <ipv6networkaddr>]
Description
The create trusted_host command creates a trusted host. The
Switch allows specifying up to 30 IPv4 or IPv6 addresses that are
allowed to manage the Switch via in-band based management
software. These IP addresses must be members of the Management
VLAN. If no IP addresses are specified, then there is nothing to
prevent any IP address from accessing the Switch, provided the
user knows the Username and Password.
Parameters
<ipaddr> − The IPv4 address of the trusted host to be created.
<network_address> − The subnet mask of the trusted host to be
created. This parameter is optional. If not specified, the default
subnet mask is 255.255.255.0.
<ipv6_addr> − The IPv6 address of the trusted host to be created.
ipv6_prefix <ipv6networkaddr> − The IPv6 subnet prefix of the
trusted network to be created. The network address of the trusted
network. The form of network address is xxx.xxx.xxx.xxx/y.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To create the trusted host:
DES-1210-52/ME:5# create trusted_host 10.90.90.91
Command: create trusted_host 10.90.90.91
Success.
DES-1210-52/ME:5#
To create the IPv6 trusted host:
DES-1210-52/ME:5# create trusted_host 3000::1
Command: create trusted_host 3000::1
Success.
DES-1210-52/ME:5#