D-Link DES-1210-52/ME - Enable Snmp Linkchange_Traps; Disable Snmp Linkchange_Traps

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
96
DES-1210-52/ME:5# show snmp traps
Command: show snmp traps
SNMP Traps : Enable
SNMP Authentication Traps : Enable
System Device Bootup : Enable
Fiber Port Link Up / Link Down : Enable
Twisted Pair Port Link Up / Link Down : Enable
RSTP Port State Change : Enable
Firmware Upgrade State : Enable
Port Security violation State : Enable
IMPB violation State : Enable
Loopback detection State : Enable
DHCP server screening State : Enable
Duplicate IP Detected State : Enable
DES-1210-52/ME:5#
enable snmp linkchange_traps
Purpose
To enable SNMP link change traps support on the Switch.
Syntax
enable snmp linkchange_traps
Description
The enable snmp linkchange_traps command is used to enable
SNMP link change traps support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable the SNMP link change trap function:
DGS-1210-28P/ME:5# enable snmp linkchange_traps
Command: enable snmp linkchange_traps
Success.
DGS-1210-28P/ME:5#
disable snmp linkchange_traps
Purpose
To disable SNMP link change traps support on the Switch.
Syntax
disable snmp linkchange_traps
Description
The disable snmp linkchange_traps command is used to disable
SNMP link change traps support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.