D-Link DES-1210-52/ME - Show Fdb

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
171
the forwarding table.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To display multicast MAC address table:
DES-1210-52/ME:5# show multicast_fdb
Command: show multicast_fdb
Static Multicast Table
------------------------------------
Total Mac Addresses displayed: 0
DES-1210-52/ME:5#
show fdb
Purpose
To display the current unicast MAC address forwarding database.
Syntax
show fdb {port <port 1-52> | vlan <vlan_name 32> |
mac_address <macaddr> | static | aging_time}
Description
The show fdb command displays the current contents of the
Switch’s forwarding database.
Parameters
<port 1-52> − The port number corresponding to the MAC
destination address. The Switch always forwards traffic to the
specified device through this port.
<vlan_name 32> − The name of the VLAN on which the MAC
address resides.
<macaddr> − The MAC address entry in the forwarding table.
static − Specifies that static MAC address entries are to be
displayed.
aging_time − Displays the aging time for the MAC address
forwarding database.
Restrictions
None.
Example usage:
To display unicast MAC address table:
DES-1210-52/ME:5# show fdb
Command: show fdb
VID VLAN Name MAC Address Port Type
---- -------------------------------- --------------------------- ------ -------------------
1 default 00-01-02-03-04-05 CPU Self
Total Entries : 1
DES-1210-52/ME:5#
To display the aging time: