D-Link DES-1210-52/ME - Qos Commands

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
180
25
QOS COMMANDS
The QoS commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config scheduling
<class_id 0-7> weight <value 1-55>
show scheduling
config
bandwidth_control
[<portlist> | all] {rx_rate [no_limit | <value 63-1000000>] | tx_rate [no_limit |
<value 63-1000000>]}
show
bandwidth_control
{[<portlist> | all]}
config cos
mac_mapping
destination_addr <macaddr> class <class_id 0-3>
show cos
mac_mapping
{destination_addr <macaddr>}
delete cos
mac_mapping
destination_addr <macaddr>
config cos ip_mapping
destination_ip <ipaddr> class <class_id 0-3>
show cos ip_mapping
{destination_ip <ipaddr>}
delete cos ip_mapping
destination_ip <ipaddr>
config cos
ipv6_mapping
destination_ipv6 <ipv6addr> class <class_id 0-3>
show cos
ipv6_mapping
{destination_ipv6 <ipv6addr>}
delete cos
ipv6_mapping
destination_ipv6 <ipv6addr>
config cos
ipv6_tc_mapping
trafficclass <class_id 0-255> class <class_id 0-3>
delete cos
ipv6_tc_mapping
trafficclass <class_id 0-255>
show cos
ipv6_tc_mapping
{trafficclass <class_id 0-255>}
config cos mapping
port [<portlist> | all] [802.1p | dscp_tos | none]
show cos mapping
{port <portlist>}
config cos
protocol_mapping
protocol <ip_protocol 1-255> class <class_id 0-3>
show cos
protocol_mapping
{protocol <ip_protocol 1-255>}
delete cos
protocol <ip_protocol 1-255>