D-Link DES-1210-52/ME - Vlan Commands

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
213
28
VLAN COMMANDS
The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
create vlan
<string 32> tag <int 2-4094> type_1q_vlan_advertisement
delete vlan
[<vlan_name 32> | vlanid <vidlist >]
config vlan
[<vlan_name 32> | vlanid <vlanid 1-4094>] [[add [tagged | untagged | forbidden] |
delete ] [<portlist> | name <vlan_name 32>] {advertisement [enable | disable]}
config gvrp
[state [enable | disable] | ingress_checking [enable | disable] | acceptable_frame
[Tagged_Only | All_Frames] | pvid <vlanid 1-4094>]
config gvrp timer
[join_timer <sec 100-100000> | leave_timer <sec 100-100000> | leave-all_timer
<sec 100-100000>]
enable gvrp
disable gvrp
show vlan
{<vlan_name 32> | vlanid <vidlist> | ports <portlist>}
create
dot1v_protocol_group
group_id <id 1-16>
{group_name <name 32>}
config
dot1v_protocol_group
[group_id <id 1-16> | group_name <name 32>] [add | delete] protocol [ethernet_2
<hex 0x0-0xffff> | ieee802.3_snap <hex 0x0-0xffff>]
delete
dot1v_protocol_group
[group_id <id 1-16> | group_name <name 32> | all]
show
dot1v_protocol_group
{group_id <id 1-16> | group_name <name 32>}
config port dot1v ports
all
[add | delete] protocol_group [group_name <name 32> | group_id <id 1-16>]
[vlan <vlan_name 32> | vlanid <id 1-4094>]
show port dot1v
{ports <portlist>}
show gvrp
{<portlist>}
show gvrp timer
enable vlan_trunk
disable vlan_trunk
show vlan_trunk
config vlan_trunk ports
[<portlist> | all] state [enable | disable]
enable asymmetric_
vlan
disable
asymmetric_vlan