DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
261
Example usage:
To configure the igmp snooping multicast VLAN:
DES-1210-52/ME:5# config igmp_snooping multicast_vlan default state enable
Command: config igmp_snooping multicast_vlan default state enable
Success.
DES-1210-52/ME:5#
delete igmp_snooping multicast_vlan
To remove an IGMP snooping multicast VLAN on the Switch.
delete igmp_snooping multicast_vlan [all | <vlan_name 32>]
The delete igmp_snooping multicast_vlan command removes
IGMP snooping multicast VLAN on the Switch.
all − Specify all vlans to be removed.
<vlan_name 32> − Specify the multicast vlan name to be removed
on the Switch.
Only administrator or operator-level users can issue this command.
Example usage:
To remove the igmp snooping multicast VLAN ‘rd1’:
DES-1210-52/ME:5# delete igmp_snooping multicast_vlan rd1
Command: delete igmp_snooping multicast_vlan rd1
Success.
DES-1210-52/ME:5#
config igmp_snooping multicast_vlan_group
To specify that IGMP snooping is to be configured for multicast vlan
groups on the Switch.
config igmp_snooping multicast_vlan_group <vlan_name 32>
[add | delete] ipv4_range <ipaddr> <ipaddr>
The config igmp_snooping multicast_vlan_group command
specifies an IGMP snooping multicast VLAN group on the Switch.
<vlan_name 32> − The name of the VLAN for which IGMP snooping
is to be configured. Up to 20 characters can be used.
[add | delete] − Specify whether to add or delete ports defined in the
following parameter <ipaddr>.
<ipaddr> − Specify the IP address range to be configured with the
IGMP snooping multicast VLAN group.
Only administrator or operator-level users can issue this command.
Example usage:
To configure the igmp snooping multicast VLAN:
DES-1210-52/ME:5# config igmp_snooping multicast_vlan_group
default add 10.90.90.93 10.90.90.95
Command: config igmp_snooping multicast_vlan_group default
To Next Page
Loading...
