D-Link DES-1210-52/ME - Config Dhcp_Relay Delete Ipif System; Config Dhcp_Relay Hops; Config Dhcp_Relay Vlan

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
117
config dhcp_relay delete ipif System
Purpose
To delete a DHCP server from the DHCP Relay server list.
Syntax
config dhcp_relay delete ipif System <ipaddr>
Description
The config dhcp_relay delete ipif System command deletes a
DHCP servers defined as a DHCP Relay server.
Parameters
<ipaddr> − The IP address of the DHCP server.
Restrictions
Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To remove a DHCP server from the DHCP Relay server list:
DES-1210-52/ME:5# config dhcp_relay delete ipif System 10.6.150.49
Command: config dhcp_relay delete ipif System 10.6.150.49
Success.
DES-1210-52/ME:5#
config dhcp_relay hops
Purpose
To delete a DHCP server from the DHCP Relay server list.
Syntax
config dhcp_relay hops <value 1-16>
Description
The config dhcp_relay hops command configures the
DHCP/BOOTP relay feature.
Parameters
hops <value 1-16> − Specifies the maximum number of relay agent
hops that the DHCP packets can cross.
Restrictions
Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To configure the DHCP relay hops on the Switch:
DES-1210-52/ME:5# config dhcp_relay hops 12
Command: config dhcp_relay hops 12
Success.
DES-1210-52/ME:5#
config dhcp_relay vlan
Purpose
To configure a VLAN of DHCP Relay to be enabled or disabled of
the Switch.
Syntax
config dhcp_relay vlan [<vlan_name 32> | vlanid <vidlist>] state
[enable | disable]
Description
The config dhcp_relay vlan command configures a VLAN of DHCP
Relay to be enabled or disable of the Switch.
Parameters
<vlan_name 32> − Specifies the VLAN name to be configured.