D-Link DES-1210-52/ME User Manual

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
220
DES-1210-52/ME:5# delete dot1v_protocol_group all
Command: delete dot1v_protocol_group all
Success.
DES-1210-52/ME:5#
show dot1v_protocol_group
Purpose
To display the protocols defined in a protocol group.
Syntax
show dot1v_protocol_group {group_id <id 1-16> | group_name
<name 32>}
Description
The show dot1v_protocol_group command displays the protocols
defined in protocol groups.
Parameters
group_id <id 1-16> − Specifies the group ID to be displayed.
group_name <name 32> − The name of the protocol group. The
maximum length is 32 characters.
Restrictions
None.
Example usage:
To display the protocol group ID 2:
DES-1210-52/ME:5# show dot1v_protocol_group group_id 2
Command: show dot1v_protocol_group group_id 2
Group ID Protocol Group Name Frame Type Protocol Value
-------------- ----------------------------------- ---------------- ------------------
2 group1 EthernetII 86dd
2 group1 IEEE802.3 SNAP 86dd
Total Entries: 1
DES-1210-52/ME:5#
config port dot1v ports all
Purpose
To assign the VLAN for untagged packets ingress from the portlist
based on the protocol group configured.
Syntax
config port dot1v ports all [add | delete] protocol_group
[group_name <name 32> | group_id <id 1-16>] [vlan
<vlan_name 32> | vlanid <id 1-4094>]
Description
The config port dot1v ports all command assign the VLAN for
untagged packets ingress from the portlist based on the protocol
group configured.
Parameters
[add | delete] −
group_name <name 32> − The name of the protocol group. The
maximum length is 32 chars.

D-Link DES-1210-52/ME Specifications

General

Brand	D-Link
Model	DES-1210-52/ME
Category	Network Router
Language	English