D-Link DES-1210-52/ME - Network Monitoring Commands; Show Packet Ports

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
139
20
NETWORK MONITORING COMMANDS
The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
show packet ports
<portlist>
show error ports
<portlist>
show utilization
[ports {<portlist>} | cpu | mem]
clear counters
{ports <portlist>}
save log
clear log
show log
{index <indexlist> | module <string 32> | severity [all | information | warning]}
enable syslog
disable syslog
show syslog
create syslog host
<index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [informational | warning |
all] | facility [local0 | local1| local2 | local3 | local4 | local5 | local6 | local7] | state
[enable | disable] | udp_port [514 | <udp_port_number 6000-65535>]}
config syslog host
[all | <index 1-4>] {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | state [enable | disable] | udp_port
[ 514 | <udp_port_number 6000-65535>] | ipaddress [<ipaddr> | <ipv6addr>]}
delete syslog host
[<index 1-4> | all]
show syslog host
{<index 1-4>}
cable diagnostic port
[<portlist> | all]
config syslogintimeout
<integer 3-30>
config sysgroupinterval
[<integer 120-1225> | 0]
show
log_software_module
Each command is listed in detail, as follows:
show packet ports
Purpose
To display statistics about the packets sent and received in frames
per second by the Switch.
Syntax
show packet ports <portlist>