DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
10
Only Administrat level users can issue this command.
Example usage:
To disable password encryption on the Switch:
DES-1210-52/ME:5# disable password encryption
Command: disable password encryption
Success.
DES-1210-52/ME:5#
create account [admin | operator | power-user | user]
<username 15>
The create account command creates an administrator, operator,
or user account that consists of a username and an optional
password. Up to 31 accounts can be created. You can enter
username and Enter. In this case, the system prompts for the
account’s password, which may be between 0 and 15 characters.
Alternatively, you can enter the username and password on the
same line.
admin − Name of the administrator account.
opeator − Specify an operator level account.
power-user − Specify an power-user level account.
user − Specify a user account with read-only permissions.
<username 1-15> − The account username may be between 1 and
15 characters.
password <password_string> {encrypted} - the account password
can be included, and (optionally) can be encrypted.
Only Administrator level users can issue this command.
Usernames can be between 1 and 15 characters.
Passwords can be between 0 and 15 characters.
NOTE: You are not required to enter a User Name. However, if you do not enter a User Name,
you cannot perform the following actions:
Create a monitor or operator (level 1 or level 14) users until an administrator user (level 15) is
defined.
Delete the last administrator user if there are monitor and/or operator users defined.
Example usage:
To create an administrator-level user account with the username ‘dlink’:
DES-1210-52/ME:5# create account admin dlink
Command: create account admin dlink
To Next Page
Loading...
